Friday, September 11, 2009

Fastest Hunting Rifle

The suBBaQQuo DIY

Having a little 'time availability' and having a tornietto Valex intrippato in the manufacture of lamps and lighting sub for my video-shoot suBBaQQue, here's a way to galvanize your accomplishments casalinGuo aluminum.

Galvanizing "DIY" is not impossible ..

Although the Vespa has, over the nuts and bolts, galvanized many parts, this article may be useful.

Zinc DIY (article from VespaForum )

To make home a "galvanizing DIY only a few vehicles and a good dose of patience and good will


The galvanizing process is very simple, just have the necessary equipment, which can be found even in large supermarkets.

These operations must be done to 'open or in a very airy.


The raw material is pure zinc. If you do not find it, just go into a store and purchase a sailing of the "sacrificial anodes" which are made of pure zinc and quite cheap.
Serve dell’acido cloridrico (detto anche acido muriatico),

dei "tensioattivi", qualsiasi sapone contenente almeno il 30% di tensioattivi va benissimo, come lo "Svelto"

.
È necessario anche un "agante splendogeno" , va benissimo la "soluzione glucosata" reperibile in farmacia o la“colla di pesce” reperibile nei supermercati.


Occorre inoltre un alimentatore a corrente continua 12 volt circa (un qualunque carica batterie va benissimo), qualche vecchia bacinella che serve da vasca, un piccolo contenitore di vetro, filo di fero, fili di rame guanti di gomma e occhiali protettivi.


Versate l'acido muriatico nel recipiente di vetro e immergetevi un pezzo di zinco. Lo zinco produrrà bollicine e si scioglierà lentamente.

L' acido è molto corrosivo e provoca gravi ustioni, quindi usate rigorosamente i guanti per proteggere le mani e gli occhiali per scongiurare che qualche schizzo possa arrivare agli occhi !!!


Lasciate lo zinco in immerso nell' acido, fino a quando non si sarà dissolto o non emit bubbles. It may take more than 24 hours of immersion.

With this process you will have generated the zinc chloride, the solution in which there are metal ions that have dissolved. Fact that these ions will gather the parts to be galvanized.


Filter the solution by passing it through a cloth, add about a tablespoon of the solution Svelto and a bar of fish paste or glucose solution and mix. The Swift is to limit the accumulation of hydrogen in the coatings, porous surfaces make galvanized. The solution glucose or the gelatin will make zinc more lucid.

It 's very important that the pieces of zinc are clean, free of grease, rust, otherwise the zinc will stick on any surface.

Pour the liquid into a bowl, take a piece of zinc and connect with a wire to the positive 's power supply, the negative is connected to the pieces of zinc, all dipping into the bowl.

often change the position of the pieces of zinc, moving, in order to obtain a uniform zinc coating on surfaces.

Stir slowly 'acid from time to time carefully. a.

after work, you should wash the pieces, and then patiently polish with a cloth.

please!! Use all appropriate caution, 'cause of' acid and electricity 'you have to go very cautious.

Obviously the undersigned disclaims any responsibility ';)


PS: I recommend products Waste must be disposed of in an appropriate manner to avoid damage to the environment! Be correct.

0 comments:

Post a Comment